The details win frames — and this is one detail worth getting right. The 3G Replacement Toe Cap is built for serious bowlers.

Features

• 3G Bowling Shoes - Toe Replacement Replacement Instructions 1
• Take the slotted screw driver and break the glued portion of the
• Cap loose by pushing it between the cap and the shoe
• This might require some pushing and turning of the screwdriver on the top as well as the bottom of the shoe. 2
• After the glue is separated, turn the shoe over, sole facing up, and push the screwdriver between the toe cap and the bottom of the shoe This will separate the
• Velcro and allow the toe cap to come off. 3
• Clean any leftover contact cement from the shoe; this may require a razor knife. 4
• Check the fit of the
• Cap by trying a "dry run"
• Certain sizes might require a small amount of trimming on the bottom of the Toe Cap
• If this is the case, CAREFULLY trim off excess material with your razor knife, the sharper, the better. 5
• Place a thin layer of contact cement on the inside of the new toe cap, mostly toward the top side, and also put contact cement on the opposing part of the shoe
• Allow the glue to cure for approximately 2 - 3 minutes before trying to put the new one on. 6
• Place the thin cardboard piece between the
• Cap and the shoe to keep the
• Velcro separated, this will allow you to push the toe cap all the way up against the front of the shoe with very little resistance

Backed by expert drilling, fast shipping, and the best prices on performance gear. Shop the full arsenal at mojoproshop.com.

Eat. Sleep. Bowl. Repeat.